Powering the board 12V problems
Quick question, for those of you who are using the 12 V adaptor to power up your devbugger, has any of you encountered the problem when sometimes you switch off the power and turn it back on the LCD turns on but doesn't display anything? But if you unplug and plug the cable it will show something again...
Views: 212
Replies to This Discussion
-
Permalink Reply by Kenny Kim on
-
Yeah I've seen that issue. Did you just lop off the adapter part and use the wires?
-
-
i used a two-pin connector that goes in the adaptor like this one http://www.ebay.com/bhp/12v-dc-connector
and just connect those two pins to 12V and ground
© 2024 Created by PML.
Powered by
