How to check EEPROM memory?

How do you know if the data has successfully been written to the EEPROM?
I tried reading and then writing (in that exact sequence) - it works. But if I erase the writing part - it doesn't see anything being written there. Does this mean that it doesn't work? Or how do i check if it worked?

Views: 28

▶ Reply to This

Replies to This Discussion

Permalink Reply by Kenny Kim on May 1, 2014 at 4:49am

if you open pic usb, push read, and then click the eeprom window, you should be able to see what is in the eeprom...

Permalink Reply by Kenny Kim on May 1, 2014 at 4:49am

take a day off... It's better for your health 

Permalink Reply by Kenny Kim on May 1, 2014 at 4:49am

or better yet, take a week off it's better for the rest of us in that it makes us feel better about taking the time off...

Permalink Reply by Kenny Kim on May 1, 2014 at 4:49am

where can you see W though?

Permalink Reply by Kenny Kim on May 1, 2014 at 4:50am

 You can't display it in the debugger...

Permalink Reply by Kenny Kim on May 1, 2014 at 4:50am

Oh I just tested it - it does remember stuff (I made sure it remembers user input after power is shut down), but I could not view it through PICUsb for some reason. Neither from MPLAB X

Permalink Reply by Kenny Kim on May 1, 2014 at 4:50am

Open picusb and press verify because it should show it...

RSS

© 2024   Created by PML.   Powered by

Badges  |  Report an Issue  |  Terms of Service

Sign in to chat!