How to switch PICs on the board?

this is likely very basic, but like, how do we switch between the PIC16/PIC18 on our board? Which one is the initial one on the board?

Views: 32

▶ Reply to This

Replies to This Discussion

Permalink Reply by Kenny Kim on May 1, 2014 at 12:15am

I think it's 16 on the devbugger but it should say on the chip?

Permalink Reply by Kenny Kim on May 1, 2014 at 12:16am

can we just pull the 16 out and put the 18 in and have it work?

Permalink Reply by Kenny Kim on May 1, 2014 at 12:16am

Yep, Use PIC-DIP 18 if you have a 18 pin PIC (found to the right of where the original pic16 was). Only ahve one pic at a time and dont reprogram the pic18 that came with the devbugger

Permalink Reply by Kenny Kim on May 1, 2014 at 12:16am

 make sure you change the JPB and RA6 as well .

Permalink Reply by Kenny Kim on May 1, 2014 at 12:17am
why shouldn't we reprogram the pic18 that came with the DevBugger? Does it contol the DevBugger?

 

Permalink Reply by Kenny Kim on May 1, 2014 at 12:17am

that pic18 I think has been specifically programmed for some function importanat the devbugger. That's the message that emami gave me

Kenny Kim said:

why shouldn't we reprogram the pic18 that came with the DevBugger? Does it contol the DevBugger?

 

Permalink Reply by Kenny Kim on May 1, 2014 at 12:18am

so there's one pic16, one pic18, and one pic18 that's with the devbugger?

Permalink Reply by Kenny Kim on May 1, 2014 at 12:19am

No. 1 PIC16 and 1 PIC18 on the board. You can replace the PIC16 with another PIC, say, PIC18.

Kenny Kim said:

so there's one pic16, one pic18, and one pic18 that's with the devbugger?

RSS

© 2024   Created by PML.   Powered by

Badges  |  Report an Issue  |  Terms of Service

Sign in to chat!