Stepper Motor Driver Help!
Did anyone figure out how to drive the stepper motor that's given in the project kit? I can't even get it to work on the driver board...
Views: 88
Replies to This Discussion
-
Permalink Reply by Francis Cedric Cruz on
-
Yeah, plug in the outputs of the stepper motor into the 2 DC inputs of the Driver board using 4 wires. Then plug in a 12V voltage from the power supply into either the DC power inputs on the driver board. There's also a switch in the middle of the board that switches between DC and BP, turn it to BP. Then you can play around with the speed and direction of the stepper motor from the BP Stepper motor part of the board. Also, don't make sure you get the GND and 12V inputs correct or you might burn the board.
-
-
Was there any specific way you plugged the 4 outputs from the stepper motor in though? I did literally the same steps and tried to change the wires around but its apparently not turning?
-
-
Maybe the start/stop switch is off
Or maybe the frequency is too high try to rotate the trimmer with a screw and it should slow down
Or try switch the jumper wire to the right of the power inputs from DC to BP.
© 2024 Created by PML.
Powered by
