Certifire door closer fitting instructions

Any Certifire approved closer to BS EN 1154, may be fitted subject to restrictions on use outlined the Certifire approval for the closer. 6mm CF160 5mm CF192 A door close is not be required for latched doorsets, used within single family occupancy dwellings. Any Certifire approved lock or latch, must be CE marked. 12mm min the maximum gap under door shall be 3mm unless a threshold seal is fitted. Trimming the door Top of door may be trimmed by up to 3mm to allow it to fit in an out of square frame, but in doing so the Certifire label must not be removed. 4mm max frame to door gap on long edges and top 3mm max 3mm max Maximum Trim The ease and speed with which it can be fixed, the fact that its spring strength can be so easily adapted to the door size and its competitive price should make the TS 71 the ideal choice for your application. Successfully third party tested to BS EN1154. CERTIFIRE Approved CF268. Inexpensive solution for standard doors. Door width up to 1100 mm. Remove the shoe from the door closer arm. 3. Attach the armset to the pivot on the door closer body parallel to the door and doorframe and secure using the washer screw. 4. Tension the door closer arm and adjust the arm length accordingly. 5. Secure the arm to the figure 66 bracket and tighten the armset nut. Click to download Certifire Certificates. Briton 121CE. Briton 1110. Briton 2320 & 2321. Briton 2700. Briton 3934. Briton 131. Briton 2000 & 2100. Briton 2420. Any CERTIFIRE approved closer, may be fitted subject to restrictions on use outlined the Failure to do so will mean that this will no longer be a Certifire ap roved fire door premdor.co.uk 0844 209 0008 CERTOFIRE CF 380 Fire Certification invalid CERTIFIED FIRE 30 with PREMDOR BARNSLEY instructions and is retained Tel: 0844 209 0008 To Fig 66 - Parallel Arm Application (Door closer fitted on push face of door) Fig. 4 Fig. 6 Fig. 5 Fig. 1 Fig. 3 Fig. 2 P ar le Ar m p l ic a t o n NO.1 NO.2 FAST SLOW No.1 Closing Speed No.2 Latching Speed _ + backcheck Delayed Action Adjust if required Adjust power strength of door closer here C LOCKW ISE NG ANTI - CLO CKW ISE LO NG Zoo Hardware Ltd Unit B Dukes Drive Kingmoor Park North Carlisle Cumbria CA6 4SH. T: +44 (0) 1228 672900; F: +44 (0) 1228 672928; E: sales@zoo-hardware.co.uk Boxer Integrated door closer for single leaf doors with a leaf width of up to 1400 mm. Closing force with variable adjustment of EN2-4 or EN3-6. Can be used for right and left hand doors without conversion. Door closer is embedded in the door leaf and frame and fulfils the highest design demands. Integrated back check, slows down doors that are Fix the closer body to the leaf using the pre- drilled pilot holes and screws supplied. Do not substitute these fixings. Position the door closer body over the pre-drilled pilot holes. Secure the closing arm and cover plate. Check operation and adjust the closing forces to meet the application. Overhead Door Closer Fitting Instructions 1 3 2 4 2. Attach the armset to the pivot on the door closer body and secure using the washer screw. 3. Tension the door closer arm and adjust the arm length accordingly. 4. Secure the armset shoe to the door and tighten the armset nut. 5. Apply the dust cap to the unused pivot. 6. Make necessary adjustments to the closing, latching, back check 2. Attach the armset to the pivot on the door closer body and secure using the washer scr