RTC code not working..

So my RTC code just stopped working. I've loaded code that worked a week ago and nothing - it gets hung on the macro which checks for the bus being free (i2c_common_stop). Anyone have ideas on solutions?

Views: 323

▶ Reply to This

Replies to This Discussion

Permalink Reply by Kenny Kim on May 1, 2014 at 5:22am

David, I mean that it is stuck on an infinite loop within that macro I mentioned.

Permalink Reply by Kenny Kim on May 1, 2014 at 5:22am

how often do you think PICs deteriorate? cause the sample codes isn't working... so I am leaning towards a pic issue

Permalink Reply by Kenny Kim on May 1, 2014 at 5:22am
Seriously put the board away and try tomorrow!!!

 

Permalink Reply by Kenny Kim on May 1, 2014 at 5:22am

Well, after 8 weeks, my PIC18's ADC module completely stopped working. That's the only info I have

Permalink Reply by Kenny Kim on May 1, 2014 at 5:22am

But id say, depending on how much you use a function, 6-10 weeks?

Permalink Reply by Kenny Kim on May 1, 2014 at 5:22am

It hasn't been that long but I have moved the pics from board to board a loooot 

Permalink Reply by Kenny Kim on May 1, 2014 at 5:22am

Yup, new pic fixed everything, thanks!

Permalink Reply by Kenny Kim on May 1, 2014 at 5:23am

You are using ADCON right? Our group had a problem that the power supply would give 5.31 instead of 5 V and then ports would burn (I think this was the case)

Permalink Reply by Kenny Kim on May 1, 2014 at 5:23am

umm, I have no idea how your group is powering the pic but you should have a voltage regulator in place (if using the simple config board) and the dev bugger has it's over power source.. so I am really confused how you were powering stuff to burn it :S

RSS

© 2024   Created by PML.   Powered by

Badges  |  Report an Issue  |  Terms of Service

Sign in to chat!