How to power the PIC?

for those who will be using microcontroller board (instead of building one by yourselves), how are you guys going to power it? Use the power adapter and connect it to a second power outlet?

Views: 41

▶ Reply to This

Replies to This Discussion

Permalink Reply by Kenny Kim on May 1, 2014 at 5:11am

I used the vcc and gnd pins on the data bus

Permalink Reply by Kenny Kim on May 1, 2014 at 5:11am
 All the peripherals run off that just fine?

 

Permalink Reply by Kenny Kim on May 1, 2014 at 5:11am

uhh, vcc will do? Cause on the manual it says vcc is not intended to power the microcontroller. And there's no guarantee it will work stably

Permalink Reply by Kenny Kim on May 1, 2014 at 5:11am

just take the AC adapter they give you, cut off the the actual adapter part, and connect the wires to your power supply. it runs off 12V

Permalink Reply by Kenny Kim on May 1, 2014 at 5:11am

^disclaimer: haven't actually done that yet, but that's what we plan to do

Permalink Reply by Kenny Kim on May 1, 2014 at 5:11am

 ^please tell me when you actually do that and it works XD

RSS

© 2024   Created by PML.   Powered by

Badges  |  Report an Issue  |  Terms of Service

Sign in to chat!